mazak-holding-one

Change Mazatrol Time

Change Time On Mazatrol Smart Control

Having Trouble Changing Time on Mazatrol Smart Control ?

Here’s how do it. –>>>>>

From the position screen, make sure that the “Smart” option is selected

Find out more about MazaCAM Editor for Mazatrol

Use the left hand side menu key to page through and find the  “diagonos ” menu key

Find out more about MazaCAM Editor for Mazatrol

This should then give you the “Data Erase” Menu key. Select this key

Find out more about MazaCAM Editor for Mazatrol

Nest select the “Accumu Time”  menu key

Find out more about MazaCAM Editor for Mazatrol

Now arrow over to the time field and type in the new time, putting a decimal point between HOURS.MINUTES.SECONDS

Find out more about MazaCAM Editor for Mazatrol

MAZACAM for OFFLINE MAZATROL PROGRAMMING.

Contact Phoenix CNC Support


Our Office


Have a question?  

Please contact us below or complete the contact form and we will be in touch shortly.

Phoenix CNC Support
Isidore Road
Bromsgrove Enterprise Park
Bromsgrove
Worcestershire
B60 3ET

T:  +44(0)7904 286 366
F:  +44 (0) 1527 870 867
E:  info@phoenixcncsupport.co.uk

W: https://phoenixcncsupport.co.uk


Chamfer Clearance Interference 707

Chamfer Cutter Interference. Error 707

Keep getting Mazatrol Error 707 Chamfer Cutter Interference.

Here’s how to fix it. –>>>>>

When you are programming a chamfer tight against a wall or close to the bottom of a counterbore. You may think that there is enough clearance top and side for the cutter to machine the chamfer.

However when you come to run the program you get Chamfer Cutter Interference error message. This is usually because there are default additional parameters settings within the TPC (Tool Path Control) that tell Mazatrol for safety to add additional clearance to the tool.

This is most likely the cause of Chamfer Cutter Interference message.

Find out more about MazaCAM Editor for Mazatrol

However with careful manipulation of the parameters, it is possible to get very close to side walls and bottom face without getting Radial interference clearance of chamfering cutter alarm if you get your settings correct. Care should be taken when altering these parameters to prevent tool collisions

Find out more about MazaCAM Editor for Mazatrol

By default Mazatrol parameters such as E1, E2, & E8* will be set to Mazak default settings. Sometimes you will need to reduce these settings to enable you to get closer to walls and surfaces and stop the Radial interference clearance of chamfering cutter alarm.  * these parameters vary from control type,

Find out more about MazaCAM Editor for Mazatrol

By editing these  default parameters you will able  to get closer to walls and surfaces and so stop Radial interference clearance of chamfering cutter.

Find out more about MazaCAM Editor for Mazatrol

MAZACAM for OFFLINE MAZATROL PROGRAMMING.

Contact Phoenix CNC Support


Our Office


Have a question?  

Please contact us below or complete the contact form and we will be in touch shortly.

Phoenix CNC Support
Isidore Road
Bromsgrove Enterprise Park
Bromsgrove
Worcestershire
B60 3ET

T:  +44(0)7904 286 366
F:  +44 (0) 1527 870 867
E:  info@phoenixcncsupport.co.uk

W: https://phoenixcncsupport.co.uk